Mobile Broadband Wireless-N Router MBRN3000 User Manual
Wireless Network Configuration 2-6
v1.0, October 2009
Configuring WEP
To configure WEP data encryption:
1. Log in to the router at its default LAN address of http://192.168.0.1 with its default user name
of admin, and default password of password, or using whatever user name, password, and
LAN address you have chosen for the router.
2. From the main menu, select Wireless Settings to display the Wireless Settings screen.
3. In the Security Options section, select the WEP (Wired Equivalent Privacy) radio button:
Security Options
(continued)
WPA2-PSK (AES) Allow only computers configured with WPA2 to connect to
the router. See “Configuring WPA, WPA2, or WPA + WPA2”.
WPA-PSK (TKIP) + WPA2-
PSK (AES)
Allow computers configured with either WPA-PSK or WPA2-
PSK security to connect to the router. See “Configuring
WPA, WPA2, or WPA + WPA2”.
Note: If you use a wireless computer to configure wireless security settings, you will be
disconnected when you click Apply. Reconfigure your wireless computer to match
the new settings, or access the router from a wired computer to make further
changes.
Figure 2-3
Table 2-1. Wireless Settings (continued)
Settings Description
To Next Page
Loading...
Need help?
General
