Mobile Broadband Wireless-N Router MBRN3000 User Manual
Advanced Configuration 5-4
v1.0, October 2009
Restricting Access by MAC Address
For increased security, you can restrict access to the wireless network to allow only specific PCs
based on their MAC addresses. You can restrict access to only trusted PCs so that unknown PCs
cannot wirelessly connect to the Wireless Router. MAC address filtering adds an obstacle against
unwanted access to your network, but the data broadcast over the wireless link is fully exposed.
To restrict access based on MAC addresses:
1. Log in to the router at its default LAN address of http://192.168.0.1 with its default user name
of admin, and default password of password, or using whatever user name, password, and
LAN address you have chosen for the router.
2. From the main menu, select Wireless Settings, and then click Setup Access List to display the
Wireless Station Access List screen.
The trusted wireless stations listed on this screen are the wireless clients that will have access
to the wireless network when the list is enabled.
Note: If you configure the Product Family from a wireless computer, add your
computer’s MAC address to the access list. Otherwise you will lose your
wireless connection when you click Apply. You must then access the router
from a wired computer, or from a wireless computer that is on the access
control list, to make any further changes.
Figure 5-2
To Next Page
Loading...
Need help?
General
