Mobile Broadband Wireless-N Router MBRN3000 User Manual
5-7 Advanced Configuration
v1.0, October 2009
1. Go to the WAN Setup screen as described in the previous section.
2. Select the Default DMZ Server check box.
3. Type the IP address for that server.
4. Click Apply to save your changes.
LAN IP Settings
The LAN IP Setup screen allows configuration of LAN IP services such as DHCP and RIP. These
features can be found under the Advanced heading in the router main menu.
The router is shipped preconfigured to use private IP addresses on the LAN side, and to act as a
DHCP server. The router default LAN IP configuration is:
• LAN IP addresses: 192.168.0.1
• Subnet mask: 255.255.255.0
These addresses are part of the Internet Engineering Task Force (IETF)-designated private address
range for use in private networks, and should be suitable in most applications. If your network has
a requirement to use a different IP addressing scheme, you can make those changes in this screen.
To view or change the LAN IP Setup:.
Warning: If you change the LAN IP address of the router while connected through the
browser, you will be disconnected and so will others connected to the router.
To connect to the router, you must open a new connection to the new IP
address and log in again. Others using the router must restart their computers
to connect to the router again.
To Next Page
Loading...
Need help?
General
