To Next Page

To Previous Page

Mobile Broadband Wireless-N Router MBRN3000 User Manual

2-13 Wireless Network Configuration

v1.0, October 2009

2. To view a list of all devices connected to your router (including wireless and Ethernet-

connected), see “Viewing Attached Devices” on page 4-8.

Adding Both WPS and Non-WPS Clients

For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless

network. You must record, and then manually enter your security settings (see “Manually

Configuring Your Wireless Settings” on page 2-4).

To connect a combination of non-WPS enabled and WPS-Enabled clients to the router:

1. Restore the router to its factory default settings (press both the Wireless and WPS buttons on

the side of the router for 5 seconds).

When the factory settings are restored, all existing wireless clients are disassociated and

disconnected from the router.

2. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the

Wireless Settings screen (see “Manually Configuring Your Wireless Settings” on page 2-4).

and click Apply. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply.

Record this information to add additional clients.

3. For the non-WPS devices that you want to connect, open the networking utility and follow the

utility’s instructions to enter the security settings that you selected in Step 2 (the SSID, WPA/

PSK + WPA2/PSK security method, and passphrase).

4. For the WPS devices that you want to connect, follow the procedure “Using a WPS Button to

Add a WPS Client” on page 2-9 or “Using PIN Entry to Add a WPS Client” on page 2-11.

The settings that you configured in Step 2 are broadcast to the WPS devices so that they can

connect to the router.

5. To view a list of all devices connected to your router (including wireless and Ethernet-

connected), see “Viewing Attached Devices” on page 4-8.

Note: To make sure that your new wireless settings remain in effect, verify that the

Keep Existing Wireless Settings checkbox is selected in the WPS Settings

screen.

NETGEAR MBRN3000 User Manual

Other manuals for NETGEAR MBRN3000