Reset / Factory Defaults button
The switch provides a recessed Reset / Factory Defaults button on the front panel so
that you can either restart (power-cycle) the switch or return the switch to its factory
default settings, causing all custom settings to be erased.
To restart the switch or return the switch to its factory default settings:
1. Insert a device such as a straightened paper clip into the opening.
2.
Do one of the following:
•
Restart the switch. Press the Reset / Factory Defaults button for about two
seconds. (Do not press the button for more than five seconds!)
The switch restarts but retains its custom settings. During this process, the Power
LED is blinking green.
•
Return the switch to its factory default settings. Press the Reset / Factory
Defaults button for at least five seconds.
The switch restarts and returns to its factory default settings. During this process,
the Power LED is blinking green.
Hardware Installation Guide15Hardware Overview
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch MS108EUP
To Next Page
Loading...
