Overview
The switch provides eight Multi-Gigabit Ethernet copper ports that support 2.5 Gbps,
1 Gbps, and 100 Mbps speed:
•
Ports 1-4: Support Ultra60 PoE++ (802.3bt), allowing each port to deliver power
up to 60W PoE++.
•
Port 5-8: Support PoE+ (802.3at), allowing each port to deliver power up to 30W
PoE+.
All copper ports use RJ-45 connectors. The switch supports a maximum PoE power
budget of 230W across all active PoE+ and PoE++ ports.
Note: For information about application examples, see Applications on page 16.
You can install the switch freestanding or mounted to a wall. The switch is IEEE compliant
and offers low latency. All ports can automatically negotiate to the highest speed, which
makes the switch very suitable for a mixed environment with multispeed Gigabit Ethernet,
Gigabit Ethernet, and Fast Ethernet.
For 2.5 Gbps and 1 Gbps Ethernet connections, use Category 5e (Cat 5e) or higher-rated
Ethernet cables terminated with RJ-45 connectors.
Features
The switch supports the following key hardware features:
•
Eight multispeed Ethernet ports (1–8), each of which supports 2.5G, 1G, and 100M.
•
Four Ultra60 PoE++ (802.3bt) ports (1–4).
•
Four PoE+ (802.3at) ports (5–8).
•
Total PoE power budget of 230W for the switch.
•
MAC table size of 16K.
•
40 Gbps line-rate, full-duplex, nonblocking switch fabric.
•
Full compatibility with IEEE standards:
- IEEE 802.3 Ethernet
- IEEE 802.3u 100BASE-T
- IEEE 802.3ab 1000BASE-T
- IEEE 802.3bz NBASE-T
Hardware Installation Guide6Introduction
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch MS108EUP
To Next Page
Loading...
