NETGEAR MS108EUP Hardware Installation Guide

Contents
Chapter 1 Introduction
Overview................................................................................................6
Features.................................................................................................6
Safety instructions and warnings........................................................7
Chapter 2 Hardware Overview
Front panel with ports and LEDs......................................................12
LEDs......................................................................................................13
Back panel...........................................................................................14
RJ-45 ports for 100/1000/2.5GBASE-T Ethernet connectivity......14
Reset / Factory Defaults button........................................................15
Chapter 3 Applications
PoE++ and PoE+ overview................................................................17
PoE++ and high-speed desktop switching.....................................18
Chapter 4 Installation
Step 1: Prepare the site......................................................................20
Step 2: Protect against electrostatic discharge..............................20
Step 3: Unpack the switch.................................................................21
Step 4: Install the switch....................................................................22
Install the switch on a flat surface.................................................22
Wall-mount the switch horizontally..............................................22
Wall-mount the switch vertically...................................................24
Mount the switch to a pole or another surface..........................24
Step 5: Connect devices to the switch.............................................25
Step 6: Check the installation...........................................................25
Step 7: Apply power and check the LEDs.......................................26
Step 8: Manage the switch................................................................26
Chapter 5 Troubleshooting
Troubleshooting chart.......................................................................28
PoE troubleshooting suggestions....................................................29
Additional troubleshooting suggestions.........................................30
4

NETGEAR MS108EUP Specifications

General

Switch type	Managed
Switch layer	L2/L3
Quality of Service (QoS) support	Yes
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	2.5G Ethernet (100/1000/2500)
Basic switching RJ-45 Ethernet ports quantity	8
10G support	No
Number of VLANs	64
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3af, IEEE 802.3at, IEEE 802.3az, IEEE 802.3bt, IEEE 802.3u, IEEE 802.3x
Virtual LAN features	Port-based VLAN, Tagged VLAN
Copper ethernet cabling technology	100BASE-T, 1000BASE-T
Jumbo frames	12000
MAC address table	16000 entries
Packet buffer memory	1.5 MB
DHCP features	DHCP client
Queue scheduling algorithms	Strict Priority Queue (SPQ), Weighted Round Robin (WRR)
Number of multicast groups filtered	128
Operating altitude	0 - 3000 m
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	0 - 90 %
Total Power over Ethernet (PoE) budget	230 W
Power source	PoE
Mean time between failures (MTBF)	373644 h
Certification	CE FCC 15 B CE/EN55032/24 CSA VCCI ACMA KC CCC BSMI
Product color	Gray
Housing material	Metal

Weight and Dimensions

Depth	140 mm
Width	210 mm
Height	40 mm
Weight	900 g