EasyManuals Logo

NETGEAR MS108EUP Hardware Installation Guide

NETGEAR MS108EUP
30 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
Additional troubleshooting suggestions
If the suggestions in the troubleshooting chart do not resolve the problem, see the
following troubleshooting suggestions:
Network adapter cards: Make sure that the network adapters that are installed in
the computers are in working condition and the software driver was installed.
Configuration: If problems occur after you alter the network configuration, restore
the original connections and determine the problem by implementing the new
changes, one step at a time. Make sure that cable distances, repeater limits, and
other physical aspects of the installation do not exceed the Ethernet limitations.
Switch integrity: If necessary, verify the integrity of the switch by restarting it. To
restart the switch, disconnect the power from the switch and then reconnect the
power. If the problem continues, contact NETGEAR technical support. For more
information, visit the support website at netgear.com/support/.
Autonegotiation: The RJ-45 ports negotiate the correct duplex mode, speed, and
flow control if the device at the other end of the link supports autonegotiation. If the
device does not support autonegotiation, the switch determines only the speed
correctly, and the duplex mode defaults to half-duplex.
The Ethernet ports negotiate speed, duplex mode, and flow control if the attached
device supports autonegotiation.
Hardware Installation Guide30Troubleshooting
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch MS108EUP

Other manuals for NETGEAR MS108EUP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR MS108EUP and is the answer not in the manual?

NETGEAR MS108EUP Specifications

General IconGeneral
Switch typeManaged
Switch layerL2/L3
Quality of Service (QoS) supportYes
Installed SFP modules quantity-
Basic switching RJ-45 Ethernet ports type2.5G Ethernet (100/1000/2500)
Basic switching RJ-45 Ethernet ports quantity8
10G supportNo
Number of VLANs64
Networking standardsIEEE 802.1Q, IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3af, IEEE 802.3at, IEEE 802.3az, IEEE 802.3bt, IEEE 802.3u, IEEE 802.3x
Virtual LAN featuresPort-based VLAN, Tagged VLAN
Copper ethernet cabling technology100BASE-T, 1000BASE-T
Jumbo frames12000
MAC address table16000 entries
Packet buffer memory1.5 MB
DHCP featuresDHCP client
Queue scheduling algorithmsStrict Priority Queue (SPQ), Weighted Round Robin (WRR)
Number of multicast groups filtered128
Operating altitude0 - 3000 m
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)0 - 90 %
Total Power over Ethernet (PoE) budget230 W
Power sourcePoE
Mean time between failures (MTBF)373644 h
CertificationCE FCC 15 B CE/EN55032/24 CSA VCCI ACMA KC CCC BSMI
Product colorGray
Housing materialMetal
Weight and Dimensions IconWeight and Dimensions
Depth140 mm
Width210 mm
Height40 mm
Weight900 g

Related product manuals