NETGEAR USB Multifunction Printer Server PS121v2 User Manual
2-16 Installation and Setup
v2.0, April 2007
e. Click Next to proceed. The following screen opens:
f. Click Finish.
3. Print a test page to verify successful printing on your network.
a. Upon completion of the Add Printer Wizard, you will be prompted to print a test page.
b. Check the printer attached to the USB Multifunction Print Server to verify that the test
page printed successfully.
If you are unable to print a test page, see Chapter 4, “Troubleshooting”
Setting up a Macintosh Computer
Macintosh computers can connect to a TCP/IP network printer using the Line Printer Remote
(LPR) protocol. LPR printing can be set up on any Macintosh that has Desktop Printing installed
or available. Desktop Printing is supported on MacOS versions beginning from 8.1. LaserWriter8
version 8.5.1 or higher is also required.
To configure the Macintosh to use the print server, follow these steps:
1. From the Apple Extras folder, under Apple LaserWriter Software, launch the Desktop Printing
Utility. A new window titled New Desktop Printer appears.
2. Select LaserWriter 8 in the “With” drop-down menu.
3. Select Printer (LPR) and click OK. A new window called Untitled 1 will open.
4. If the PostScript Printer Description does not match your printer, click Change... and select
your actual printer.
Figure 2-21
To Next Page
Loading...
Need help?
General
