Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
3-12 Basic Installation and Configuration
July 2005 v3.0
Figure 3-7: IP Settings menu
• Access Point Name (NetBIOS)
Enter a new name for the wireless access point and click Apply to save your changes.
• The IP Address
The wireless access point is shipped preconfigured with its DHCP client disabled and with the
following private static IP addresses:
– IP Address — 192.168.0.228
– IP Subnet Mask — 255.255.255.0
– Gateway — 0.0.0.0
– Primary and Secondary DNS Servers — 0.0.0.0
If your network has a requirement to use a different IP addressing scheme, you can make those
changes in this menu. These settings are only required if the “Use this IP address” radio button
is chosen. Remember to click Apply to save your changes.
To Next Page
Loading...
