NETGEAR WG302 - 802.11g ProSafe Wireless Access Point User Manual

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
3-22 Basic Installation and Configuration
July 2005 v3.0
4.
Select encryption strength.
5. You can manually or automatically program the four data encryption keys. These values must
be identical on all PCs and Access Points in your network.
• Automatic - enter a word or group of printable characters in the Passphrase box and click
the Generate button. The four key boxes will be automatically populated with key values.
• Manual - enter ten hexadecimal digits (any combination of 0-9, a-f, or A-F)
Select which of the four keys will be the default.
See “Overview of WEP Parameters” on page B-5 for a full explanation of each of these
options, as defined by the IEEE 802.11 wireless communication standard.
6. Click Apply to save your settings.
How to Configure WPA with Radius
Note: Not all wireless adapters support WPA. Furthermore, client software is required on the
client. Windows XP and Windows 2000 with Service Pack 3 do include the client software that
supports WPA. Nevertheless, the wireless adapter hardware and driver must also support WPA.
Consult the product document for your wireless adapter and WPA client software for instructions
on configuring WPA settings.
To configure WPA, follow these steps:
1. Log in at the default LAN address of http://192.168.0.228 with the default user name of
admin and default password of password, or using whatever LAN address and password you
have set up.
Note: If you use a wireless computer to configure WEP settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match the
new settings or access the wireless access point from a wired computer to make any
further changes.

NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Specifications

General

Brand	NETGEAR
Model	WG302 - 802.11g ProSafe Wireless Access Point
Category	Wireless Access Point
Language	English