Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
Basic Installation and Configuration 3-23
July 2005 v3.0
2.
Click Radius Server Settings in the Security menu.
Figure 3-12: Radius Server Settings
3.
Enter the Radius settings.
• Authentication/Access Control Radius Server Configuration: This configuration is
required for authentication using Radius. IP Address, Port No. and Shared Secret is
required for communication with Radius Server. A Secondary Radius Server can be
configured which is used on failure on Primary Radius Server
• IP Address: The IP address of the Radius Server. The default is 0.0.0.0.
• Port Number: Port number of the Radius Server. The default is 1812.
To Next Page
Loading...
