NETGEAR WG302 - 802.11g ProSafe Wireless Access Point User Manual

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
Advanced Configuration 5-9
July 2005 v3.0
How to Configure a WG302 as a Point-to-Point Bridge
Figure 5-7: Point-to-Point Bridge
1.
Configure the WG302 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.
2. Configure the WG302 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode.
AP1 must have AP2’s MAC address in its Remote MAC Address field and AP2 must have
AP1’s MAC address in its Remote MAC Address field.
3. Configure and verify the following parameters for both access points:
• Verify that the LAN network configuration of the WG302 Access Points both are
configured to operate in the same LAN network address range as the LAN devices
• Both use the same ESSID, Channel, authentication mode, if any, and security settings if
security is in use.
4. Verify connectivity across the LAN 1 and LAN 2.
• A computer on either LAN segment should be able to connect to the Internet or share files
and printers of any other PCs or servers connected to LAN Segment 1 or LAN Segment 2.
LAN
Segment 1
Router
AP in
Point-to-Point
Bridge Mode
AP in
Point-to-Point
Bridge Mode
LAN
Segment 2
Hub or Switch
AP1
ETHERNET
RESET
5-12V DC
AP2
ETHERNET
RESET
5-12V DC

NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Specifications

General

Brand	NETGEAR
Model	WG302 - 802.11g ProSafe Wireless Access Point
Category	Wireless Access Point
Language	English