NETGEAR WG302 - 802.11g ProSafe Wireless Access Point User Manual

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
3-32 Basic Installation and Configuration
July 2005 v3.0
5.
Click WEP/WPA Settings in the Security menu.
Figure 3-19: WEP/WPA Settings menu
6.
Choose WAP and WPA2 with Radius from the list.
7. Click Apply to save your settings.
How to Configure WPA2-PSK and WPA2-PSK
Note: Not all wireless adapters support WPA. Furthermore, client software is required on the
client. Windows XP and Windows 2000 with Service Pack 3 do include the client software that
supports WPA. Nevertheless, the wireless adapter hardware and driver must also support WPA.
Consult the product document for your wireless adapter and WPA client software for instructions
on configuring WPA settings.
Note: Not all wireless adapters support WPA2. Furthermore, client software is required on the
client. Make sure your client card supports WPA2. Consult the product document for your wireless
adapter and WPA2 client software for instructions on configuring WPA2 settings.
To configure WPA-PSK and WPA2-PSK, follow these steps:
1. Log in at the default LAN address of http://192.168.0.229 with the default user name of
admin and default password of password, or using whatever LAN address and password you
have set up.

NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Specifications

General

Brand	NETGEAR
Model	WG302 - 802.11g ProSafe Wireless Access Point
Category	Wireless Access Point
Language	English