Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
3-16 Basic Installation and Configuration
July 2005 v3.0
Understanding WEP/WPA Security Options
The table below identifies the various WEP/WPA security options. A full explanation of these
standards is available in Appendix B, “Wireless Networking Basics”.
Figure 3-9: Wireless Security Settings
The WEP/WPA settings are explained as follows:
• Network Authentication: Specifies the Authentication type used. The default is Open
System. Select the desired option:
– Open System: If selected, you have the option of using WEP encryption, or no
encryption.
– Shared Key: If selected, you must use WEP; at least one shared key must be entered.
– Legacy 802.1x: If selected, you must configure the Radius Server Settings Screen.
– WPA-PSK: If selected, you must use TKIP encryption, and enter the WPA passphrase
(Network key).
– WPA with Radius: If selected, you must configure the Radius Server Settings Screen.
– WPA2-PSK: WPA2 is a later version of WPA. Only select this if all clients support
WPA2. If selected, you must use AES encryption, and enter the WPA passphrase
(Network key).
To Next Page
Loading...
