NETGEAR WG302 - 802.11g ProSafe Wireless Access Point User Manual

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
3-24 Basic Installation and Configuration
July 2005 v3.0
• Shared Secret: This is shared between the Wireless Access Point and the Radius Server
while authenticating the supplicant.
• Re-authentication Time: The time interval in seconds after which the supplicant will be
authenticated again with the Radius Server. The default is 3600 seconds.
• Global-key Re-Key Time: Check on this option to enable Re-keying of Global Key. The
Global Key Re-Key can be done based on time interval in seconds or number of packets
exchanged using the global key. The default is 3600 seconds.
• Update if any station disassociates: Check on this option to refresh global key when any
stations disassociated with wireless Access Point.
• Accounting Radius Server Configuration: This configuration is required for accounting
using Radius Server. IP Address, Port No. and Shared Secret is required for
communication with Radius Server. A Secondary Radius Server can be configured which
is used on failure on Primary Radius Server.
• IP Address: The IP address of the Radius Server. The default is 0.0.0.0.
• Port Number: Port number of the Radius Server. The default is 1813.
• Shared Secret: This is shared between the Wireless Access Point and the Radius Server
while authenticating the supplicant.
4. Click Apply to save your settings.
5. Click WEP/WPA Settings in the Security menu.
Figure 3-13: Wireless Settings menu

NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Specifications

General

Brand	NETGEAR
Model	WG302 - 802.11g ProSafe Wireless Access Point
Category	Wireless Access Point
Language	English