EasyManuals Logo

NETGEAR WGR614 User Manual

NETGEAR WGR614
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
Preparing Your Network C-1
Appendix C
Preparing Your Network
This appendix describes how to prepare your network to connect to the Internet through the Model
WGR614 Cable/DSL Wireless Router and how to verify the readiness of broadband Internet
service from an Internet service provider (ISP).
Preparing Your Computers for TCP/IP Networking
Computers access the Internet using a protocol called TCP/IP (Transmission Control Protocol/
Internet Protocol). Each computer on your network must have TCP/IP installed and selected as its
networking protocol. If a Network Interface Card (NIC) is already installed in your PC, then TCP/
IP is probably already installed as well.
Most operating systems include the software components you need for networking with TCP/IP:
•Windows
®
95 or later includes the software components for establishing a TCP/IP network.
Windows 3.1 does not include a TCP/IP component. You need to purchase a third-party TCP/
IP application package such as NetManage Chameleon.
Macintosh Operating System 7 or later includes the software components for establishing a
TCP/IP network.
All versions of UNIX or Linux include TCP/IP components. Follow the instructions provided
with your operating system or networking software to install TCP/IP on your computer.
Note: If an ISP technician configured your computer during the installation of a
broadband modem, or if you configured it using instructions provided by your ISP, you
may need to copy the current configuration information for use in the configuration of
your firewall. Write down this information before reconfiguring your computers. Refer
to “Obtaining ISP Configuration Information for Windows Computers” on page C-19 or
“Obtaining ISP Configuration Information for Macintosh Computers” on page C-20 for
further information.

Table of Contents

Other manuals for NETGEAR WGR614

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WGR614 and is the answer not in the manual?

NETGEAR WGR614 Specifications

Power IconPower
power adapter voltage12 VDC
Interface and Networking IconInterface and Networking
internet WAN10/100 Mbps (auto-sensing) Ethernet, RJ-45
LAN ports4 ports 10/100 Mbps (auto-sensing) Ethernet, RJ-45
wireless network speeds1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, & 54 Mbps (auto-rate capable)
Wireless Specifications IconWireless Specifications
modulation typeOFDM with BPSK, QPSK, 16QAM, 64QAM, DBPSK, DQPSK, CCK
frequency range US2.412 ~ 2.462 GHz
frequency range Japan2.412 ~ 2.484 GHz
frequency range Europe ETSI2.412 ~ 2.472 GHz
frequency range Spain2.457 ~ 2.462 GHz
frequency range France2.457 ~ 2.472 GHz
Security IconSecurity
encryption40-bit (also called 64-bit), 128-bit, and 152-bit (802.11g only) WEP encryption, WPA (Wi-Fi Protected Access)
firewallStateful Packet Inspection (SPI), DoS Attack Detection/Logging, Dropped Packet Log, Security Event Log, E-mail Log
Weight and Dimensions IconWeight and Dimensions
dimensions6.9 x 1.1 x 4.7 in (175.3 x 27.94 x 119.4 mm)
weight0.3 kg (0.7 lb)
antenna gain2 dBi

Related product manuals