NETGEAR WGX102

Configuring the WGX102 in Router Mode 4-1
September 2004 202-10042-01
Chapter 4
Configuring the WGX102 in Router Mode
This chapter describes how to set up the WGX102 as the only router on your local area network
(LAN) and connect to the Internet. If you already have another router on your LAN, you do not
need to configure the WGX102 in Router Mode and do not need to read this chapter. The figure
below illustrates the 54 Mbps Wall-Plugged Wireless Range Extender WGX102 in Router Mode:
Figure 4-1: WGX102 in Router Mode
Note: You can only use one XE102 bridge. You cannot have any other XE102 bridges on the same
network.
You will find out how to configure your 54 Mbps Wall-Plugged Wireless Range Extender
WGX102 for Internet access using the Setup Wizard, or how to manually configure your Internet
connection.
Follow these instructions to set up your range extender.