Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102
5-12 Wireless Configuration
September 2004 202-10042-01
4. Then, either select from the list of available wireless cards the WGX102 has found in your
area, or enter the MAC address and device name for a device you plan to use. You can usually
find the MAC address printed on the wireless adapter.
Note: You can copy and paste the MAC addresses from the Attached Devices menu into the
MAC Address box of this menu. To do this, configure each wireless computer to obtain a
wireless link to the WGX102. The computer should then appear in the Attached Devices
menu.
5. Click Add to add this wireless device to the Wireless Card Access List. The screen changes
back to the list screen. Repeat these steps for each additional device you wish to add to the list.
6. Select the Turn Access Control On check box.
7. Be sure to click Apply to save your wireless access control list settings.
Now, only devices on this list will be allowed to wirelessly connect to the WGX102.
To Next Page
Loading...
