Need help?Do you have a question about the Netgenium AUG3201-IP and is the answer not in the manual?
Describes how to log in and the default username/password for initial access.
Configures IP address, subnet mask, and default gateway settings.
Configures audio output levels and general settings.
Configures analogue audio input and gain settings.
Registers the gateway as a telephony end point using SIP or Skinny.
Sets up Cisco IP Telephony integration and phone emulation.
Resets the unit to its original factory default settings.
Details the procedure for updating the device firmware.
General| Switching Capacity | 56 Gbps |
|---|---|
| Forwarding Rate | 41.7 Mpps |
| MAC Address Table Size | 8K |
| Ports | 4 x 100/1000Base-X SFP ports |
| Management | Web, CLI, SNMP |
| Power Supply | 100-240V AC, 50/60Hz |
| Operating Temperature | 0°C |
| Storage Temperature | 70°C |
To Next Page