Netis WF-2404 - Dhcp; DHCP Settings; DHCP Clients List

300Mbps Wireless-N Broadband Router User Manual
49
4.6. DHCP
4.6.1. DHCP Settings
Figure 4-39
 DHCP Server Status: Keep the default setting “Enable”, so router is able to use DHCP
function. If a DHCP server has already existed in the network, please select “Disable”.
 Start IP Address: The IP Address is used for allocate IP address by DHCP server; enter the
start IP address.
 End IP Address: The IP Address is used for allocate IP address by DHCP server; enter the
end IP address.
4.6.2. DHCP Clients List
Display the state of assigned IP by DHCP Server.
Figure 4-40