Select ‘LAN setup’-‘DHCP server’ ,select disable DHCP server.
Figure 4-35
AP3:
Select radio mode is ‘REPEATER’in wireless management-basic of AP3.
Click ‘AP Scan’ in wireless management-basic of AP3 ,and select ‘Netis1’ and Connect ,
then the ‘Repeater SSID’ and ‘Channel’ become same as AP2.
The IP address of AP3 should be 192.168.1.x (1<x<255),but different from AP2.
Select ‘LAN setup’-‘DHCP server’ ,select disable DHCP server.
4.5.6. Wireless Advanced
These settings are only for more technically advanced users who have a sufficient knowledge
about wireless LAN. These settings should not be changed unless you know what effect the
change will have on your AP.
To Next Page
Loading...
