DRIVER’S CHECK LIST
26 Copyright © 1998 New Flyer Industries Ltd.
Lights
• Clean and clear of obstructions.
• Lens not broken.
• No missing lights or lenses.
Indicator Lights
☞ NOTE:
From this point on items on the driver’s checklist requires activat-
ing the vehicle’s Programmable Logic control (PLC) System and
starting the engine. Turning the Master Run switch on the side
console to DAY-RUN or NIGHT-RUN activates the PLC system
after a six-second “wake-up” interval. Wait for the system to acti-
vate before starting the engine. For details on engine starting,
refer to Section 8: Vehicle Operation.
• The Stop Request indicator illuminates by activating the
passenger signal system.
• The W/C Stop Request indicator illuminates by pressing the
wheelchair station touch tape.
• The Parking Brake indicator illuminates when the parking
brake is applied.
• The Stop indicator illuminates when the brakes are applied.
• The Turn indicator illuminates and flashes when the Turn
Signal switch is activated or the Hazard switch is turned on.
• The Rear Door Open indicator illuminates when the exit door is
opened and flashes when the Door Master switch is off.
• The High Beam indicator illuminates when the high beam
headlights are ON.
• The No Gen and Stop Engine indicators illuminate
momentarily, then extinguish.
• The remaining indicators relate to vehicle operation problems
and should be checked by service personnel.
To Next Page
