VEHICLE OPERATION
82 Copyright © 1998 New Flyer Industries Ltd.
Jump Start Connection
Behind the battery disconnect access door is a jump start connec-
tor to supply power to the batteries when normal engine starting is
not possible. It uses a quick connect assembly to ensure a safe
and correct electrical connection to the battery poles.
☞ NOTE:
Advise the control center if starting difficulties occur.
Operating the Vehicle in Reverse
Reverse operation of the vehicle requires paying special attention
to the articulating joint angle. Just as a trailer can reach a “jack-
knife” position the articulating joint can reach a potentially damag-
ing maximum angle position. To reduce this risk, vehicle safety
systems limit reverse speed to 3 mph and an alarm warns of artic-
ulating maximum angle.
The interlocks apply upon reaching the articulating joint maximum
angle to stop further reverse movement. To release the interlocks
and allow movement for correction; use the Door Master toggle
inside the driver’s locker.
CAUTION:
Continuing in reverse after disengaging the inter-
locks, risks damage to the articulating joint.
Engine Protection System
The New Flyer vehicle is equipped with an automatic shutdown
system to prevent engine damage. If the Stop Engine indicator
illuminates, the engine protection system will begin the engine
shut down sequence. Engine power will be reduced for 30 sec-
onds. After that time the engine will shut down.
To Next Page
