INSTRUMENTATION & CONTROLS
Copyright © 1998 New Flyer Industries Ltd. 67
Door Master Switch
The Door Master toggle switch controls power to the door and
interlock systems. It is located in behind the driver’s locker access
door.
Position the switch to ON for normal operation of the doors and
interlock systems. The following engages the interlocks to apply
the rear brakes and deactivate the accelerator:
• Opening the exit doors.
• Operating the wheelchair lift.
• Exceeding the articulating joint critical angle.
Positioning the Door Master toggle switch to OFF, deactivates the
door and interlock systems. The doors must then be operated
manually.
☞ NOTE:
Turn the Door Manual control valve to manually operate the
entrance door when in the OFF position.
CAUTION:
The OFF position allows opening the exit door
while the vehicle is in motion. Use only if the vehi-
cle is in a dangerous position. When operating in
this mode give greater attention to passenger
safety.
ABS Switch
The ABS switch, located in the driver’s locker, is used by service
personnel to troubleshoot the ABS System. Pulling the switch to
BLINK CODE and releasing, activates the blink code diagnostic
capabilities. The blink code sequence displays on the instrument
panel ABS Fail indicator light.
To Next Page
