VEHICLE OPERATION
74 Copyright © 1998 New Flyer Industries Ltd.
☞ NOTE:
When re-starting less than 30 minutes after engine shut down, the
PLC System responds instantly.
WARNING:
Put the shift selector in neutral [N] and apply the
parking brake before starting the engine. If the
Parking Brake indicator does not illuminate DO
NOT OPERATE THE VEHICLE.
Start Push Button Switch
With the vehicle’s PLC System active, push the Start push button
switch until the engine starter engages and starts the engine.
When the engine starts, release the push button switch.
If the starter fails to operate, check the following:
• The Master Run switch is in the DAY-RUN or NIGHT-RUN
position.
• The transmission selector switch indicator lamp shows neutral
[N].
• The engine compartment Master Run switch is in the FRONT
position.
• The park brake is applied.
☞ NOTE:
DO NOT crank the engine for more than 14 seconds at a time.
Allow a 60-second cooling interval before cranking the starter
again.
To Next Page
