6000 Vortex Series Getting Started • 9
Getting Started
Introduction
This section outlines the basic steps needed to start using your Vortex
laser system, including information on unpacking the system and brief
set-up and starting notes. For more detailed information on how to
operate the instrument, refer to the “General Operation” chapter
beginning on page 13.
Unpacking the System
Carefully unpack the Vortex laser system. Compare the contents
against the packing slip and inspect them for any signs of damage. If
parts are missing or you notice any signs of damage, such as dented or
scratched covers, or broken knobs, please contact New Focus
immediately.
For orders with multiple heads, up to 3 heads may be shipped in the same
container.
Save the shipping container and packing material for future shipping
needs.
Check that the power module on the back of the controller is set for the
proper AC line voltage (see page 53 for information on checking and
changing the voltage).
Note:
Note:
Note:
Note:
Vortex6000.book Page 9 Tuesday, February 19, 2002 3:25 PM
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General