Newtec EL470 - Page 143

Modem Reference Manual for EL470 IP Satellite Modem
/Modem/Monitor/Interfaces/Ethernet/IP termination/S2BBFoE Rx Statistics
Only valid for mode Eth (ntS2BBFoE).
Structured Command
IfS2BBFoERxCounters
S2BBFoE RX counters S2BBFoE RX counters
Location /Modem/Monitor/Interfaces/Ethernet/IP termination/S2BBFoE Rx Statistics
Only valid for DVB-S2 modes.
Description
Readout of the DVB-S2 baseband frames over Ethernet RX counters. The
following counters are read out: IfS2BBFoERxFramesRxed,
IfS2BBFoERxTranspHdrErrors, IfS2BBFoERxDflErrors and
IfS2BBFoERxAcmErrors.
RMCP
Command
s2e Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfS2BBFoERxCounters
OID 1.3.6.1.4.1.5835.3.1.4.1.171.1.1
Variables
IfS2BBFoERxFramesRxed
IfS2BBFoERxTranspHdrErrors
IfS2BBFoERxDflErrors
IfS2BBFoERxAcmErrors
Page
204
204
205
205
/Modem/Monitor/Interfaces/Ethernet/ipencap/Protocols/ULE Statistics
Only valid for the following modes:
• Eth(IP)
• Air(TS)
Command
IfUleStatsReset
Statistics Counters
Mode
Statistics Counters
Location /Modem/Monitor/Interfaces/Ethernet/ipencap/Protocols/ULE Statistics
Description
Configuration command to specify when the ULE statistics counters are
reset internally.
• Reset each period: The counters are set to zero when a statistics
period (5 s) is reached.
• Never: The counters continue to run freely.
• Reset on get: The counter is reset each time the values are gotten.
RMCP
Command
IUr Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfUleStatsReset
OID 1.3.6.1.4.1.5835.3.1.4.1.112.1.1
version 3.1
136
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS