Newtec EL470 - Test

Modem Reference Manual for EL470 IP Satellite Modem
Test
EL470 >> Test
In this section of the menu you can start some tests with the unit.
/Modem/Test/Interfaces
Command
GbeTestRst
GBE Test Reset GBE Test Reset
Location /Modem/Test/Interfaces
Description
This command performs a reset of the gigabit Ethernet board for test
purposes.
RMCP
Command
GTR Access Normal user : no access
Expert user : W
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01GbeTestRst
OID 1.3.6.1.4.1.5835.3.1.4.1.181.1.1
Values Factory Default Enumeration Value
Disable configuration 1
Command
MoBufTimeLimit
Max Eth-to-mod
buffering delay
Max Eth-to-mod buffe
Location /Modem/Test/Interfaces
Description
Configuration of the maximum buffering delay for Ethernet packets that
travel from the Ethernet interface to the modulator. This value is especially
important when traffic goes from a variable rate network (e.g. Ethernet) to
a network with a lower bitrate (the satellite link).
RMCP
Command
Mbd Access Normal user : no
access
Expert user : RW
SNMP Table ntcDevsMod01ModulatorEntry
Command ntcDevsMod01MoBufTimeLimit
OID 1.3.6.1.4.1.5835.3.1.3.1.100.1.1
Values GUI Unit
ms
Cmd Unit Factory Default (CU)
ms 750
Expert Range (CU)
0 .. 30000
version 3.1
235
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS