Unit Menu
Reference Manual for EL470 IP Satellite Modem
4 UNIT MENU
In this section of the menu you can control and monitor the operational parameters
of the device. The parameters to use the device as test generator or bit error
monitor are also explained. When you are logged in as administrator or in expert
mode, additional (non-frequently used) parameters become available. When you
are logged in as operator or in normal mode, only relevant operational parameters
are shown.
/Unit
/Unit/Setup
Special Command
SyDevMode
Device mode Device mode
Location /Unit/Setup
Description
Configuration of the device operation mode. The following device
operating modes are defined:
• Normal mode: This is the standard operating mode which enables
the default set of parameters that are most frequently used.
• Expert mode: This mode gives an expert operator access to an
additional set of more advanced parameters.A password is required
to switch to expert mode. This password is the model number of the
device.
RMCP
Command
SMm Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyDevMode
OID 1.3.6.1.4.1.5835.3.1.1.1.18.0.1
Get Command Arguments Set Command Arguments
Command(s) / Variable(s) Page Command(s) / Variable(s) Page
none none SyDevModeState
SyDevModePass
188
228
Get Reply Values Set Reply Values
Command(s) / Variable(s) Page Command(s) / Variable(s) Page
SyDevModeState 188 SyDevModeReply
SyDevModeState
229
188
version 3.1
12
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
To Next Page
Loading...
