Introduction
Reference Manual for EL470 IP Satellite Modem
Parameter Table
Introduction
There are specific tables for three types of commands:
• Command
• Structured Command
• Special Command
These types of commands are described in detail in the following paragraphs.
Request a RMCP and SNMP manual via the Newtec Service
Desk tool:
> Browse to http://customersupport.newtec.eu
> Fill in your Username and Password
> Create a ticket
As response of your request you will receive the manual from our
support team.
In case you don't have a Username and Password yet for the
Newtec Service Desk tool request a login to
techsupport@newtec.eu
'Normal' Command
Description
The 'normal' command is a command that sets or gets the value of a variable in the
device.
You can use a 'normal' command:
1. As stand alone.
2. As stand alone and used in a structured or special command. In this case a link
towards the command is added in the structured or special command.
3. As part of a structured or special command only. In this case the location in the
command description is NA (Not Applicable). In the command description there
is a link to both the structured and special command in which this 'normal'
command is used.
version 3.1
2
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
To Next Page
Loading...
