Unit Menu
Reference Manual for EL470 IP Satellite Modem
Special Command
WIUsers
WI user WI user
has to use.Remark: The following access rights are possible:
• Minimum or read-only access.
• Operator or limited access.
• Administrator or full access.
RMCP
Command
WIu
array : [1 .. 4]
Access Normal user : no access
Expert user : W
SNMP Table ntcDevsMod01SystemExtEntry
Command ntcDevsMod01WIUsers
OID 1.3.6.1.4.1.5835.3.1.1000.1.6.1.1.[1 .. 4]
Get Command Arguments Set Command Arguments
Command(s) / Variable(s) Page Command(s) / Variable(s) Page
NA NA WILogInUser
WILogInUserAccess
WILogInOldPass
WILogInPass
194
194
194
195
Get Reply Values Set Reply Values
Command(s) / Variable(s) Page Command(s) / Variable(s) Page
NA NA WILogInReply 195
/Unit/Control
Command
SyDevSleepMode
Device sleep mode Device sleep mode
This command is only available using the front panel.
Location /Unit/Control
Description
Configuration of the device sleep mode. The sleep mode control allows
the user to power-down the device without actually removing the power or
using a power switch.
• Operational: The device is fully operational and responds to input
from keyboard and RMCP commands.
• Sleep mode: The device is put in a low power-consumption (power
down) state and ignores all monitoring and control from RMCP. It
can be awakened by pressing a front panel key after which it will
perform a boot-cycle.
RMCP
Command
DSM Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyDevSleepMode
OID 1.3.6.1.4.1.5835.3.1.1.1.30.0.1
Values Factory Default
operational
Enumeration Value
Operational
Sleep
0
1
version 3.1
20
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
To Next Page
Loading...
