Newtec EL470 - Page 72

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfEthMcastIf
Multicast interface Multicast interface
OID 1.3.6.1.4.1.5835.3.1.4.1.191.1.1
Values Factory Default
none
Enumeration Value
None
Interface A
Interface B
0
1
2
/Modem/Control/Interfaces/Ethernet/IP termination/MPEG over IP
Only valid for Eth (TSoIP) processing mode.
Command
IfMPEGoUDPRXSettings
Format
RX Format RX Format
Location /Modem/Control/Interfaces/Ethernet/IP termination/MPEG over IP
Description
Configuration of the type of protocol stack that the transport stream
packets are encapsulated on. This setting applies to the reception format
of UDP packets.
• UDP: User datagram protocol.
• RTP: Real time transmission protocol.
• TS: MPEG transport stream.
RMCP
Command
VRf Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfMPEGoUDPRXSettingsFormat
OID 1.3.6.1.4.1.5835.3.1.4.1.146.1.1
Values Factory Default
UDPTS
Enumeration Value
UDP/TS
UDP/RTP/TS
0
1
Command
IfMPEGoUDPRXSettings
Type
RX IP type RX IP type
Location /Modem/Control/Interfaces/Ethernet/IP termination/MPEG over IP
Description
Configuration of what type of network transmission is used. The type of IP
addressing can be unicast or multicast.
Remark: This setting applies to the reception of UDP packets.;
RMCP
Command
VRt Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfMPEGoUDPRXSettingsType
version 3.1
65
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS