PPA5xx/15xx communications manual
2-64
Reads phase meter results.
Sets phase meter mode if not already set.
Waits for next unread data if available.
Clears new data available bit read by
DAV?
phase:
PHASE1
PHASE2
PHASE3
PHASES?
5 data values separated by commas
freq,mag1,mag2,dB,phase
PHASEM,CH1
PHASEM,PHASE1?
data returned
The phase convention can be set to 0 to
-360, 0 to +360, or +180 to -180 in
the SYSTEM menu or using PHCONV
command.
PHASEM? without specifying the phase
returns the appropriate single phase data.
To Next Page
Loading...
