EasyManuals Logo

Newtons4th PPA500 User Manual

Newtons4th PPA500
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
PPA5xx/15xx communications manual
1-4
1.1 Standard event status register
PON
CME
EXE
DDE
QYE
OPC
bit 0 OPC (operation complete)
cleared by most commands
set when data available or sweep complete
bit 2 QYE (unterminated query error)
set if no message ready when data read
bit 3 DDE (device dependent error)
set when the instrument has an error
bit 4 EXE (execution error)
set when the command cannot be executed
bit 5 CME (command interpretation error)
set when a command has not been recognised
bit 7 PON (power on event)
set when power first applied or unit has reset
The bits in the standard event status register except for
OPC are set by the relevant event and cleared by specific
command (*ESR?, *CLS, *RST). OPC is also cleared by
most commands that change any part of the configuration
of the instrument (such as MODE or START).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Newtons4th PPA500 and is the answer not in the manual?

Newtons4th PPA500 Specifications

General IconGeneral
BrandNewtons4th
ModelPPA500
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals