GEO S12 HARDWARE SETUP PROCEDURE
System Manual GEOS12 LS18 Page 27 / 95
6.2.5 Warnings on GEO S12 & LS18 accessories
WARNING
All GEO S12 and LS18 accessories are specifically rated in agreement with structural computations.
Never use other accessories – including push-pins - when assembling GEO S12 and/or LS18 cabinets than
the ones provided by NEXO: NEXO will decline responsibility over the entire GEO S12 and LS18 accessory
range if any component is purchased from different supplier.
WARNING 2
For SAFETY reasons, following first generation accessories:
- GEOS12-XBOW
- GEOS12-TCBRK
- GEOS12-SSBRK
- GEOS12-PSBRK
- GEOS12-TTC
Have been recalled in August 2007 and MUST NO LONGER BE USED
These accessories have been replaced by:
- GPT-XBOW
- GPT-TCBRK
- GPT-SSBRK
- GPT-PSBRK
- GPT-TTC
Please contact your local distributor if any doubt in relation the GEO S12 & LS18 accessories you are using.
WARNING 3
All GEO S12 accessories have been designed so that cabinets are arrayed in the acoustic coupling plane
(adjacent waveguides as shown in figures below).
GEO S12 assemblies in the “non-coupling plane” – as shown in figure below- are UNSAFE and STRICTLY
PROHIBITED.
YES YES NO