Nexo GEO S12 Series System Manual

GEO S12 HARDWARE SETUP PROCEDURE
Page 42 / 95 System Manual GEOS12 LS18
6.4.3 Single GEO S12 flown vertically
Required items
- 1 x Flying Bar for single vertical GEO S12 (VNT-TTC)
- 1 x Lifting Ring (VNT-XHBRK)
- Or 1 x Truss hook (VNT-TCBRK)
IMPORTANT
Ensure that truss suspension point is strong enough to hold GEO S12 weight.
Procedure
- Slide flying bar VNT-TTC into GEO S12 connecting plate oblong holes
- Lock safety pin into GEO S12 connecting plate
IMPORTANT
Ensure that safety pin is properly locked into GEO S12 connecting panel.
Cable suspension:
- Connect lifting ring VNT-XHBRK to flying bar by inserting 8x45 quick release pin in required holes for proper vertical aiming
- Ensure lifting ring is properly locked to flying bar
- Connect assembly to suspension point with sling and shackle (not provided)
Truss suspension:
- Connect truss hook VNT-TCBRK to flying bar by inserting 8x45 quick release pin in required holes for proper vertical aiming
- Ensure truss hook is properly locked to flying bar
- Lift and position assembly, lock hook on truss suspension point and secure with hook cable

Nexo GEO S12 Series Specifications

General

Brand	Nexo
Model	GEO S12 Series
Category	Speaker System
Language	English