Nexo GEO S12 Series System Manual

GEO S12 HARDWARE SETUP PROCEDURE
System Manual GEOS12 LS18 Page 43 / 95
6.4.4 Single GEO S12 flown horizontally
Required items
- 1 x “U” Bracket for single horizontal GEO S12 (GPT-SSBRK)
- 1 x Lifting Ring (VNT-XHBRK)
- Or 1 x Truss hook (VNT-TCBRK)
IMPORTANT
Ensure that suspension point is strong enough to hold GEO S12 weight
Procedure
- Slide GPT-SSBRK side plates into GEO S12 connecting plate oblong holes
- Lock safety pins into GEO S12 connecting plate
IMPORTANT
Ensure that safety pins are properly locked into GEO S12 connecting panels.
- Position “U” bracket over these side plates, align centre holes
- Insert adjustment handles, adjust vertical angle and tight the handles to prevent GEO S12 from rotating around “U” bracket
Cable suspension:
- Connect lifting ring VNT-XHBRK to “U” bracket by inserting 8x45 quick release pin dedicated holes
- Ensure lifting ring is properly locked to “U” bracket
- Connect assembly to suspension point with sling and shackle (not provided)
Truss suspension:
- Connect truss hook VNT-TCBRK to “U” bracket by inserting 8x45 quick release pin in dedicated holes
- Ensure truss hook is properly locked to “U” bracket
- Lift and position assembly, lock hook on truss suspension point and secure with hook cable

Nexo GEO S12 Series Specifications

General

Brand	Nexo
Model	GEO S12 Series
Category	Speaker System
Language	English