GEO S12 HARDWARE SETUP PROCEDURE
Page 56 / 95 System Manual GEOS12 LS18
- Connect the reinforcement bar to the supporting beams according to required tilt angle configuration using 2 axis per side;
secure the axis with provided “R” clips
- Insert GPT-XBOW into connecting plates of both sides GEO S12s
- Insert LST-XBOW into connecting plates of LS18s
- Lock safety pins into LS18s and GEO S12s connecting plate
IMPORTANT
Ensure that safety pins are properly locked into LS18s and GEO S12s connecting panels.
To Next Page
Loading...
Need help?
General
