From here you can adjust whole setting and function of HD-STB.
If you press the MENU button, the menu screen will display.
You can move up and down using UP or DOWN button in the menu system. Press OK or RIGHT
button to select the items. MENU button will go back to one step back.
If there is no remote control activity more than 60 sec, then all menu will automatically
disappear for prevent unwanted operation.
6) Press MENU to exit the menu.
1. User Preference
FromhereyoucanadjustUser PreferencesettingsconcerningyourTV.
You can select desired audio signal from broadcaster. If you select Dolby Digital
and broadcaster simultaneous broadcast the Dolby Digital and MPEG audio, then
your HD-STB willcheckuptheDolby Digital audio first and decode Dolby Digital
audio.
If you select Dolby Digital but broadcaster broadcast MPEG audio only, then your
HD-STB willcheckuptheDolby Digital audio first and next select MPEG audio
automatically.
AlsoyoucansetupA udio Preference (I-II) with I-II button on the remote control.
But this change is affected to selected channel only. If you change channel or turn
off the HD-STB, then default audio type will be selected.
1) Press MENU to display the menu.
2) Press OK or RIGHTtoselecttheUser Preference menu.
3) Press RIGHTtoselectsub-menu.
4) Press UP or DO
WN to select desired audio mode.
5) Press OK or RIGHTtosavetheselectedaudiomode.
Preferred Audio Type (I-II)
9
Using the MENU System
SD Output Aspect Ratio
i-Plate Banner Duration
Front Panel LED Dimmer
Power Restore
You can select best fitting display mode for your SD TV screen.
This function is available only Composite Video and S-Video output when the 16:9
source is coming from Broadcaster. The 16:9formatisthestandardmodeformost
wide TV screens. You can select Widescreen or 4:3 Letter Box for fit your SD TV s
screen.
1) Press MENU to display the menu.
2) Press OK or RIGHTtoselecttheUser Preference menu.
4) Press RIGHTtoselectsub-menu.
5) Press UP or DOWN to select desired display format.
6) Press OK or RIGHT to save the selected display format.
You can adjust Information Banner (i-Plate) time duration. If you feel i-Plate time is
too long or short, you can select time out period using i-Plate Banner Duration
setup.Itisaffectedwithi-Plate and 7-DAY EPG displa
y.
.
You can adjust front LED display brightness. If you feel the front panel LED is too
brighter or darker, you can adjust the brightness of LED display using Front Panel
LED Dimmer setup.
This HD-STB has Power Restore function. If you setup the Power Restore to Enabled
and when AC main power is restored, the HD-STB will automatically turn on and
display final memorized channel. It is useful for multiple display or exhibition for
control the HD-STB. After setup the Power Restore to Enabled,justturnontheAC
main power for HD-STB on and turn off the AC main power for HD-STB off. The
factory default value is Power Restore Disabled.
3) Press DOWN to select display format menu.
7) Press MENU to exit the menu.
2
To Next Page
Loading...