EasyManua.ls Logo

NextWave Digital THD-6190 - Important Safeguards; Installation and Ventilation Guidelines

NextWave Digital THD-6190
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
These important safeguard messages will help ensure your enjoyment and proper
use of the HD-STB and accessories. Please read them carefully before you begin
to operate your HD-STB product.
This User's Guide should be read before the HD-STB is operated and retained for
future reference.
This HD-STB should be operated only from the type of power source indicated on
the rear panel.
Do not place HD-STB on an unstable trolly, stand, tripod, bracket, or table as it
may fall, causing serious injury to a child or adult and damage the HD-STB.
If an outside antenna or cable system is connected to the HD-STB,besurethe
antenna or cable system is grounded to provide some protection against
voltage surges and built-up static charges. An outside antenna system should
not be located in the vicinity or overhead power lines, or other power circuits,
whereitcanfallontosuchpowerlinesorcircuits.When installing an outside
antenna system, extreme care should be taken to keep from touching or
approaching such power lines or circuits as contact with them might be fatal. I
nstalling an outdoor antenna can be hazardous and should be left to a
professional antenna installer.
Opening slots in the STB cabinet are provided for ventilation to ensure reliable
STB operation and to protect it from overheating. HD-STB should not be located
in an enclosed / built-in installation such as a bookcase unless proper
Ventilation is provided.
For sufficient ventilation, there must be at least 10cm free air space above,
behind, top and on each side of the HD-STB.
Do not expose the HD-STB to direct sunlight. This product should be situated
away from heat sources such as radiators, heat registers, stoves and other
electronic products (including amplifiers) that produce heat.
1. Read and Retain this User's Guide
2. Use Correct Power
3. HD-STB Installation
4. Provide Antenna Ground
5. Provide Proper Ventilation
6. Keep AwayfromHeat
Important Safeguards
7. Keep Away from Moisture
8. Do Not Open
9. Unplug before Cleaning
10. Object and Liquid Entry
11. For Additional Protection
DonotuseHD-STB near water or in wet areas such as near a bathtub, wash
bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool and
The like.
Caution:Maintain electrical safety, Power line operated equipment or
accessories connected to this unit should bear the CE listingmarkorC-Tick
certification mark on the accessory itself and should not be modified to defeat
the safety features. This will help avoid any potential hazard from electrical
shockorfire.
DonotattempttoservicethisHD-STB, as opening or removing STB cover will
expose you to dangerous voltages. To prevent of the risk of fire or electric shock,
do not open the cabinet. There are no user serviceable parts inside the HD-STB.
Refer servicing to qualified service personnel only.
WhencleaningtheHD-STB,turntheHD-STB power off and unplug it from the
wall AC outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.
Useadampclothforcleaningonly.
Never push objects of any kind through HD-STB openings as they may touch
dangerous voltage points or short-outpartsthatcouldresultinafireorelectric
shock.
Never spill liquid of any kind on the HD-STB.Incaseof liquidspillage,
please contact your qualified service center.
For added protection during a lightning storm, or when left unattended for long
periods of time, unplug the HD-STB from the AC wall outlet and disconnect the
antenna and A/V cable system. This will prevent damage to the HD-STB from
Lightning and power line surges.
Important Safeguard

Table of Contents