NI cDAQ-917x User Manual
© National Instruments | I-3
F
features, 1-11
features, counter, 5-38
filters
digital input (parallel DIO modules
only), 4-6
PFI, 4-13
FREQ OUT signal, 5-36
frequency
division, 5-31
generation, 5-29
generator, 5-30
measurement, 5-10
Frequency Output signal, 5-36
G
generations
analog output data, 3-1
buffered hardware-timed
analog output, 3-2
digital output, 4-9
continuous pulse train, 5-26
digital output data, 4-8
frequency, 5-29
hardware-timed
analog output, 3-2
digital output, 4-8
pulse for ETS, 5-31
pulse train, 5-24
retriggerable single pulse, 5-25
simple pulse, 5-23
single pulse, 5-23
single pulse with start trigger, 5-24
software-timed
analog output, 3-1
digital output, 4-8
getting started
AI applications in software, 2-7
AO applications in software, 3-6
DI applications in software, 4-7
DO applications in software, 4-13
with the cDAQ chassis, 1-1
H
hardware-timed generations
analog output, 3-2
digital output, 4-8
help, technical support, B-1
I
implicit buffered
pulse-width measurement, 5-5
semi-period measurement, 5-9
installation, 1-5
instrument drivers (NI resources), B-1
K
KnowledgeBase, B-1
L
LabVIEW documentation, A-2
LabWindows/CVI documentation, A-2
LEDs, 1-12
M
Measurement Studio documentation, A-3
measurements
buffered two-signal edge-
separation, 5-22
choosing frequency, 5-14
frequency, 5-10
implicit buffered pulse-width, 5-5
implicit buffered semi-period, 5-9
period, 5-17
position, 5-18
pulse-width, 5-5
semi-period, 5-8
single pulse-width, 5-5
single semi-period, 5-9
single two-signal edge-separation, 5-21
two-signal edge-separation, 5-21
using quadrature encoders, 5-18
using two pulse encoders, 5-20
To Next Page
