Index
I-4 | ni.com
measuring
high frequency with two counters, 5-11
large range of frequencies using two
counters, 5-12
low frequency, 5-10
minimizing glitches on the output signal, 3-6
mounting, 1-7
desktop use, 1-7
DIN rail, 1-10
panel, 1-8
N
National Instruments support and
services, B-1
.NET languages documentation, A-4
NI support and services, B-1
NI-DAQmx
device documentation browser, A-1
documentation, A-2
O
on-demand edge counting, 5-3
output signals, minimizing glitches, 3-6
P
panel mounting, 1-8
pause trigger, 5-37
period measurement, 5-17
PFI, 4-13
BNC connectors, 1-13
filters, 4-13
position measurement, 5-18
buffered, 5-20
power connector, 1-13
prescaling, 5-38
programming examples (NI resources), B-1
pulse
encoders, 5-20
generation for ETS, 5-31
train generation, 5-24
continuous, 5-26
pulse-width measurement, 5-5
implicit buffered, 5-5
single, 5-5
Q
quadrature encoders, 5-18
R
reciprocal frequency measurement, 5-12
related documentation, A-1
retriggerable single pulse generation, 5-25
routing
clock, 6-1
digital, 6-1
S
safety guidelines, 1-2
for hazardous voltages, 1-3
sample clock measurement, 5-20
sample clock, edge counting, 5-4
semi-period measurement, 5-8
implicit buffered, 5-9
single, 5-9
simple pulse generation, 5-23
single
point edge counting, 5-3
pulse generation, 5-23
retriggerable, 5-25
with start trigger, 5-24
pulse-width measurement, 5-5
semi-period measurement, 5-9
two-signal edge-separation
measurement, 5-21
software (NI resources), B-1
software-timed generations
analog output, 3-1
digital output, 4-8
start trigger, 5-37
status LEDs, 1-12
STC3, 1-15
strain relief, 1-12
support
technical, B-1
synchronization modes, 5-38
100 MHz source, 5-39
external source less than 40 MHz, 5-39
internal source less than 40 MHz, 5-39
To Next Page
