9.0 [S] Service menus
9.1.1 [S] DM start heating9.1.0 [S] Heat pump settings
9.1.2 [S] DM start cooling
9.1.3 [S] Stop temp. heat low
9.1.4 [S] Stop temp. heat high
9.1.5 [S] Stop temp. cool low
9.1.6 [S] Stop temp. cool high
9.1.7 [S] Time bet. starts
9.1.8 [S] Min CompFreq act/set
9.1.9 [S] Max CompFreq act/set
9.1.10 [S] OU current heat act/max
9.1.11 [S] OU cur. cool act/max
9.1.12 [S] Tank defrost Temp.
9.1.13 [S] Return
9.2.1 [S] DM start add. heat9.2.0 [S] Add. heat settings
9.2.2 [S] Time factor
9.2.6 [S] Shunt amplification
9.2.7 [S] Shunt amplification2
9.2.8 [S] Add. heat type
9.2.9 [S] Return
9.3.1 [S] Max. boiler temp.9.3.0 [S] Operating settings
9.3.2 [S] Logger
9.3.3 [S] Cooling system
9.3.4 [S] Heating system 2
9.3.5 [S] Room unit
9.3.6 [S] Room sensor type
9.3.7.1 [S] Forced control9.3.7.0 [S] Forced control
9.3.7.2 [S] K1
9.3.7.3 [S] K2
9.3.7.4 [S] K3
9.3.7.5 [S] K4
9.3.7.6 [S] K5
9.3.7.7 [S] K6
9.3.7.8 [S] K7
9.3.7.9 [S] K8
9.3.7.10 [S] K9
9.3.7.11 [S] K10
9.3.7.12 [S] K11
9.3.7.13 [S] K12
9.3.7.14 [S] K13
9.3.7.15 [S] K14
9.3.7.16 [S] Alarm 1
9.3.7.17 [S] Alarm 2
9.3.7.18 [S] Return
9.3.8 [S] Factory setting
9.3.9 [S] Operating state
9.3.10.1 [S] Floor drying9.3.10.0 [S] Floor drying setting
45NIBE™ SPLIT ACVM 270
Miscellaneous
Control
To Next Page
Loading...
Need help?
General
