Menu 9.8.x.1 [S] Time
Menu 9.8.x.2 [S] Alarm type
See section Alarm list on page 61 for further alarm inform-
ation.
CauseAlarm num-
ber
HP alarm1
LP alarm2
TB alarm3
OU power failure4
Low condenser out5
High KF6
Anti freeze HX7
High HW temp.8
High AH temp.9
High VBF110
High VBF211
High VBR112
High VBR213
OU not compatible15
Defrosting interrupted16
Sensor fault UG30
S. fault HP31
Sensor fault KF32
S. fault Liquid line33
S. fault HW34
S. fault AH35
Sensor fault VBF136
Sensor fault VBF237
Sensor fault VBR138
Sensor fault VBR239
OU phase errorE34
High HX tempE35
High hotgasE36
Sensor fault OUE37
Sensor fault OUE38
Sensor fault OUE39
HP alarmE40
Inverter errorE41
Inverter errorE42
Inverter errorE45
Inverter errorE47
Fan alarmE48
LP alarmE49
Inverter errorE51
Sensor fault OUE53
LP alarmE54
Low refrigerantE57
Inverter errorE59
Menu 9.8.x.3 [S] Run status
Menu 9.8.x.4 [S] Run status last
Menu 9.8.x.5 [S] Run status time
Menu 9.8.x.6 [S] Run time compressor
Menu 9.8.x.7 [S] Outdoor avg. 1min.
Menu 9.8.x.8 [S] Outdoor temp Tho-A
Menu 9.8.x.9 [S] Supply/Return temp
Menu 9.8.x.10 [S] Condensor out
Menu 9.8.x.11 [S] Hot water temp.
Menu 9.8.x.12 [S] CompFreq act/set
Menu 9.8.x.13 [S] Heat Ex Tho-R1
Menu 9.8.x.14 [S] Heat Ex Tho-R2
Menu 9.8.x.15 [S] Suction temp. Tho-S
Menu 9.8.x.16 [S] Hot gas Tho-D
Menu 9.8.x.17 [S] Liquid line temp.
Menu 9.8.x.18 [S] HP
Menu 9.8.x.19 [S] LP LPT
Menu 9.8.x.20 [S] OU current CT
Menu 9.8.x.21 [S] Inverter temp Tho-IP
Menu 9.8.x.22 [S] Circ-pump speed
Menu 9.8.x.23 [S] Relay status 1-8
Menu 9.8.x.24 [S] Relay status 9-14
Menu 9.8.x.25 [S] Program status 1-8
Menu 9.8.x.26 [S] Program status 9-16
Menu 9.8.x.27 [S] Return
Return to menu 9.8.x.0.
Menu 9.8.5 [S] Clear alarm log
Select ”Yes” to erase the entire alarm log. The settings re-
turns to ”No” once the action has been carried out.
Setting range: Yes, No
Menu 9.8.6 [S] Return
Return to menu 9.8.0.
Menu 9.9 [S] Return
Return to menu 9.0.
NIBE™ SPLIT ACVM 27060
Miscellaneous
Control
To Next Page
Loading...
Need help?
General
