Carefully pull out the cooling module.
TIP
The cooling module is installed in reverse order.
NOTE
At reinstallation, the supplied O-rings must re-
place the existing ones at the connections to
the heat pump (see image).
USB service outlet
The display unit is equipped with a USB socket that can
be used to update the software, save logged information
and handle the settings in F1155.
INDOOR CLIMATE
HEAT PUMP INFO
HOT WATER
USB
update firmware
USB 7
logging
manage settings
When a USB memory is connected a new menu (menu
7) appears in the display.
Menu 7.1 - update firmware
update firmware7.1
start updating
choose another file
This allows you to update the software in F1155.
NOTE
For the following functions to work the USB
memory must contain files with software for
F1155 from NIBE.
The fact box at the top of the display shows information
(always in English) of the most probable update that the
update software has selected form the USB memory.
This information states which product the software is
intended for, the software version and general informa-
tion about them. If you wish to select another file than
the one selected, the correct file can be selected by
"choose another file".
57Chapter 9 | ServiceNIBE F1155
To Next Page
Loading...
Need help?
General
