Nidac VST62 - Status LED in Operating Mode; Default Codes

10
3.1.2 Status LED in Operating Mode
In operating mode the Status LED indicates the conditions below.

-
Neither relay is currently active.

Green
-
Lock relay is currently active (door unlocked).

Red
-
Auxiliary relay is currently active (door unlocked).

Orange
-
Both Lock & Auxiliary relays are currently active.

Orange
- Single  key press registered.

Red
-
Double

key press registered.
What the Status LED indicates in Manager and Installer modes are given
in the relevant sections.
3.2 DEFAULT CODES
There are 3 default codes in the VST keypads that can be used for
setting up and testing the installation.
The following table gives the default codes based on the code length
selected in setting 969 of the installer programming section (refer page
21). The factory default setting for code length is 0 (variable code length
from 3 to 8 digits).
Code Length
Setting
Default
Installer
Code
Default Manager
& Lock Test Code
Default Auxiliary
Lock Test Code
0
9999
1111
2222
3
999
111
222
4
9999
1111
2222
5
99999
11111
22222
6
999999
111111
222222
7
9999999
1111111
2222222
8 99999999 11111111 22222222
The various default codes will automatically be disabled under the
following conditions:-
The default Installer code is disabled when a new installer code is
programmed.