11
The default Manager code is disabled when a new Manager code is
programmed; it will be enabled again if all programmed manager
codes are deleted.
The default Lock and Auxiliary codes are disabled when any new
code is programmed; they will be enabled again if all programmed
user codes are deleted.
The Default Auxiliary code will also be disabled if the Auxiliary Relay
is not set as Lock Control.
3.3 USER CODES
There are 3 levels of users codes available in the VST keypads to
provide different access levels, all of these code levels can be used for
opening the door. Each code level is described below.
3.3.1 Managers
Mangers are the highest level codes providing the ability to operate the
door(s), perform advanced code functions (refer Advanced Code
functions on page 12) and they allow access to the manager mode to
add and remove user codes.
3.3.2 Primary Users
Primary users are intermediate level codes and can be used to operate
the door(s) and perform advanced code functions (refer Advanced Code
functions on page 12).
3.3.3 Standard Users
Standard users are the lowest level codes and can only be used to
operate the door(s). These codes may also be locked out by the
Auxiliary input and/or the Manager and Primary user codes depending
upon options set in the Installer Setting Programming.
To Next Page
Loading...
