21
4.20 Setting 969 – Reset keypad to factory defaults
Allowed Value = 246
Enter 246 into this setting location to reset the keypad back to factory
defaults.
NOTE programming this setting will erase all existing codes. The new
value for this setting needs to be confirmed by entering the current
installer code then after the programming sequence.
969 246 <installer code>
4.21 Setting 999 – New installer code
The value entered into this setting will become the new installer code
and will disable the default installer code.
There can only be 1 installer code so programming of this setting will
overwrite any previously programmed installer code.
The installer code cannot be the same as any of the default codes or any
user codes.
To Next Page
Loading...
