27
6 ENABLE/DISABLE INSTALLER CODE
Once the system has been commissioned and all the installer mode
settings are correct, it is highly recommended that the Installer Code
be disabled.
The reason for this is to ensure that someone who knows the installer
code cannot use it to set the relay mode and in effect open the door
without using a user code.
Enabling/Disabling the installer code is performed by entering the
manager mode.
The factory default manager code is 1111.
To enter manager mode press <manager code>
(the final is not required when using fixed length codes)
The keypad will beep 5 times and the Mode LED will be flashing Green
- Disables the Installer Code
- Enables the Installer Code
To exit manager mode press , the keypad will sound 3 sets of 2
quick beeps.
To Next Page
Loading...
